Electric Vacuum Pump
Electric Vacuum Pump. Very sturdy construction with great pumping capabilities for all high demand vacuum experiments.
Specifications:
Single Stage: RS-2
Pumping step (CFM) *: 2
Pumping rate: 4
Pressure: 10 – 30 Pa
Rotation speed (per minute): 1440 rpm
Air-Bleeding Speed: 2.5m3 / h
Power: 180Watt / 1 / 3Hp
Oil introduction: 220ml
Oil inlet valve diameter: Φ6
Dimensions: 319/125/243 mm
Weight: 11 kg
Power supply: 220V / 50Hz
The package includes the appropriate oil for the pump and hose.
* CFM: Volumetric flow of the valve. The volume of air that moves per minute.
It can be used for maintenance and repair of refrigerators, air conditioners, printers, car air conditioners, in medical instruments, in a chemical laboratory, in industries but also for photomechanical processes.
The pump consists of the following parts:
We have the electric motor at the back, the compressor at the front, a handle at the top and a support base at the bottom. There is an inlet connected to the system to remove air from the system and we also have the exhaust to disperse it into the atmosphere. At the front of the compressor we will find an oil level glass, so we can tell how much oil is in the chamber and its condition.
instructions for use
Unscrew the valve in the oil tank. Fill to the brim with clean pump oil (HFV-1).
Close the valve tightly and check for leaks.
Connect the pump to the power supply and turn the switch to ON.
MAINTENANCE INSTRUCTIONS
Check regularly that the oil is at the right level. At a lower level the operation of the pump is affected and can even cause damage.
The oil must be changed after 250-300 hours of operation. If the oil is contaminated with chemicals, oxidized or contaminated with solid particles it must be changed immediately.
After changing the oil, let the pump run for 15-30 minutes. Stop the pump, unscrew the drain valve and drain the old oil completely. Fill with 330mL of new oil and let the engine run for 1 minute to rinse the pump compartment and repeat 2-3 times. Once the pump is clean, refill with new oil and the pump is ready for use.
You can clean any drops and stains from oil using EXANIO.