Danger Shield Kit

24,31 € (πλέον ΦΠΑ)


Κωδικός: 709597 Κατηγορία:

Περιγραφή Προϊόντος

we cant wait to see what youre able to do with it! The shields features include:

The Danger Shield mounts on top of your Arduino or Arduino Pro and equips it with a variety of fun and useful inputs and outputs. The Danger Shield has so much potential we can’t wait to see what you&apos re able to do with it! The shield’s features include:

Three linear slide potentiometers connected to the Arduino’s analog pins 0 through 2.

Red and yellow LEDs connected to digital pins 5 and 6 – PWM pins – so you can easily vary their brightness.

Three momentary push buttons connected up to the Arduino&apos s digital pins 10 through 12. Those lines will go low when the buttons are pressed.

A photocell and a temperature sensor, both with analog outputs, are connected to the analog pins 3 and 4, respectively.

An 8-bit shift register set up to control a blue 7-segment LED.

Two buzzers – one is used, as you&apos d expect, as a speaker, the other is connected to analog pin 5 and can be used as a knock sensor.

This new version uses a different temperature sensor. This product comes as a kit of parts, which you’ll have to solder into the included PCB. All parts are through-hole so it should go together relatively easily but always check your component orientation before soldering!

Kit Includes:

1x PCB Danger Shield Kit

3x Slide Potentiometers – 10K

1x 7-Segment LED – Blue

1x 8-bit Shift Register – 74HC595

1x Temperature Sensor – TMP36

1x Miniature Photocell

2x Buzzers

1x Basic LED – Red

2x Basic LEDs – Yellow

1x Mini Push Button

3x Momentary Push Buttons – 12mm Square

11x Resistors – 330 Ohm

4x Resistors – 10K Ohm

1x Resistor 1M Ohm 1/6W

2x 8-pin Arduino Stackable Headers

2x 6-pin Arduino Stackable Headers



Eagle Files

Example Code




Eagle Files

Example Code