Adding GPS to your Arduino has never been easier. The EM406 plugs easily onto the shield, and with the example sketch, you will be able to locate your exact position within a few meters. Here’s where we are. GPS also gives you amazingly accurate time!
The DLINE/UART switch switches the GPS module’s input/output between Arduino’s standard TX/RX pins or any digital pins on the Arduino (default setting uses pins 3 and 2 connected to TX and RX, respectively). The regular GPS pins (RX, TX, PPS, etc.) are broken out to a 10-pin 0.1″ pitch header, and a small protoyping area is also provided. An ON/OFF switch is included which controls power to the GPS module. Additionally, the Arduino reset switch is also brought out.
Note: The DLINE/UART switch must be set to DLINE in order to upload code through the Arduino IDE.
A GPS quickstart guide and a GPS Shield Assembly Guide are available for this product.
Features:
- EM-406 connector populated
- Standard Arduino sized shield
- Prototyping area
- GPS serial and PPS signals broken out to a 0.1″ header for additional device connections
- Arduino reset button
- DLINE/UART switch controls serial communications
- ON/OFF switch controls power to GPS module
Kit Includes:
- 1 x GPS Shield
- 1 x EM-406A SiRF III GPS Receiver
- 2 x Stackable Headers 6-pin
- 2 x Stackable Headers 8-pin
Documents: